Dr. Pulley Variator Slide Set (Majesty 125)

Description: Dr. Pulley Variator Slide Set for Yamaha Majesty 125. The slide pieces in the variator are equally as important as the rollers. It is highly recommended to change the slide pieces to coincide with the rollers. The Dr. Pulley Variator Slides are made of the same abrasion-resistant nylon as the Dr. Pulley Roller Weights, which promises a long life.

Installation: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face slop-side and boss flat-side. Should be flushed together. 3. Then install the existing variator fan, washer, and hand-tight nut. 4. Finally, apply blue Loctite, torque nut to 30-35ft-lbs. For reassurance please consult your manufacturer's variator torque specs.

Specifications:

•    3x Plastic Slides
•    Made in Taiwan
•    Fit Roller Weights 20x17mm
•    Fit Dowel Pin Set (8x14mm)
•    Fit Majesty 125

Supported Models: Yamaha Majesty 125

-----
Item Weight & Package Dimensions:
•    0.005 pounds | 2" (L) x 1.5" (W) x 0.2" (H)