G- CVT Belt 654-18-30 (Honda Dio)
Description: G- Premium CVT Drive Belt size 654-18-30 is made in Japan, not China's version. Its material used is Nylon previously used in making bullet-proof vests. Nylon strong yet it's flexible, not harsh on aluminum drive face like "Kevlar" which are recommended for heavier duty off-road applications. Nylon makes it gentle on CVT recommended for everyday riding use. CVT Drive Belt size 654-18-30 commonly found on Honda Dio 50, Honda Elite 50, and many other makes and models.
Installation: Make sure variator drive face is seated properly and not get its teeth chewed by the Bendix: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face slop-side and boss flat-side. Should be flushed together. 3. Then install the existing variator fan, washer, and hand-tight nut. 4. Finally, apply blue Loctite, torque nut to 30-35ft-lbs. For reassurance please consult your manufacturer's variator torque specs.
Include the following belt.
• Nylon Reinforced Material
• Length: 654mm (Loop 12.874 in.)
• Width: 18.2mm (0.708 in.)
• Groove Angle: 30°
• Fit Variator Boss 20mm
• Fit Roller Weights: 16x13mm
• Fit Plastic Slides
• Fit Compression Spring: 1k, 1.5k, 2k rpm
• Fit Dowel Pin Set (8x14mm)
• Fit DIO 50/90cc+
Supported Models: TFC CVT KIT (Part# 179-2); Honda Dio AF16 AF18E 50; Elite S/SE/SR 1994-2001, Daelim Cordi 50, Kymco Fever/ZX50, SYM DD50, and virtually any scooter engine with these measurements.
Item Weight & Product Dimensions:
• 0.18 pounds | 12.874” (L) x 0.708” (W) x 0.354” (H)