Stage6 Clutch Spring Sport Pro (Aprilia, JOG, Zuma 50)
Description: Stage6 Clutch Spring Sport Pro for Aprilia, JOG, Zuma 50, and many other 50cc base engines. 3 sets of Clutch springs for Stage6 Sport Pro and stock clutches. Harder clutch springs result in the clutch engagement at higher revs (and therefore higher power development), which gives much better acceleration from standstill.
Installation: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face slop-side and boss flat-side. Should be flushed together. 3. Then install the existing variator fan, washer, and hand-tight nut. 4. Finally, apply blue Loctite, torque nut to 30-35ft-lbs. For reassurance please consult your manufacturer's variator torque specs.
Include the following Clutch spring set.
• 9x Clutch Springs: RPM / L: mm
• Spring ID: mm / OD: mm
• Wire Diameter: mm
• Made in Italy
• Fit Clutch: 107mm / Sheave: 33mm / Bearing Funnel: 42mm / Nut: M28 / Socket: 39mm / Bell Spline: 16
• Fit Belt Size: 818-19-28 (Fit Aprilia ONLY)
• Fit Belt Size: 788-17-30 (Fit JOG ONLY)
• Fit Belt Size: 748-18-28 (Fit Zuma ONLY)
• Fit Compression Spring: 1k, 1.5k, 2k rpm
• Fit Clutch Springs: 1k, 1.5k, 2k rpm
• Fit Aprilia 50
• Fit JOG 50
• Fit Zuma 50
Supported Models: NCY CVT KIT (Part# 1200-1197); Yamaha C3, Yamaha Zuma CW50, Yamaha Zuma 50F, Yamaha Vino Minarelli Jog engines, Chinese Yamaha Clones 1PE40QMB 1E40QMB engines, Malaguti, CPI, Aprilia Scooters with Piaggio engines, and Franco-Morini 50cc engines found in the 1E41QMB Suzuki AD50 AG50, TGB R50X, TGB 101, TGB 303, and Peirspeed Scooters.
Item Weight & Package Dimensions:
• 0.0125 Pounds | 5.315" (L) x 3.170" (W) x 1" (H)
From Same Category
- Stock: 40
- Reward Points: 1
- Part #: S6-5316620