Stage6 Kickstart Castle Washer R/T (Minarelli)

Description: Stage6 Kickstart Castle Washer R/T for Minarelli Engine. This little castle washer sits at the end of the crankshaft and connects to the kickstart pinion gear. it is an essential part of the transmission, so in case it is damaged or missing, please replace immediately.

Installation: Make sure variator drive face is seated properly and not get its teeth chewed by the Bendix: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face slop-side and boss flat-side. Should be flushed together. 3. Then install the existing variator fan, washer, and hand-tight nut. 4. Finally, apply blue Loctite, torque nut to 30-35ft-lbs. For reassurance please consult your manufacturer's variator torque specs.

Specifications:

Include the following Kickstarter castle washer.

•    1x Kick Start Castle Washer Splines: / ID: mm / OD: mm / H: mm
•    Fit Minarelli

Supported Models: AGM 50, ATU 50, Adly 50, Aprilia 50, Boatian 50, Benelli 50, Benero 50, Benzhou 50, Beta 50, Buffalo 50, CPI 50, Diamo 50, E-Ton 50, Eppella 50, Explorer (ATU), Forstinger 50, GT Union 50, Garelli 50, Generic 50, Hercules 50, Italjet 50, Itteco 50, Jm Motor 50, Jack Fox 50, Jmstar 50, Jonway 50, KTM 50, Kallio 50, Keeway 50, Kreidler 50, Lifan 50, Longjia 50, MBK 50, Malaguti 50, Mash 50, Mawi 50, Meteorit (ATU), Motobi 50, Motofino 50, Motomojo 50, Motorro 50, Motowell 50, Motoworx 50, Muz / MZ, Nova Motors 50, PGO 50, Powersports Factory 50, Pulse 50, Qianjiang 50, REX (Jinan Qingqi Shenke), RIDE 50, RS Ultima 50, Revonec 50, Rieju 50, Rivero 50, Sachs 50, Sacom 50, Saro 50, Seiran 50, Sprint 50, TNG 50, TNT Motor 50, Tank 50, Tauris 50, Vento 50, Yamaha 50, Yamati 50, Znen 50, and virtually any other scooter engine with these measurements.

-----

Item Weight & Product Dimensions:
•    0.18 pounds | 2.165" (OD) x 0.531" (ID) x 0.287" (H)