SSP-G Variator Roller Weight Set 20x12 (Vino, Zuma 125)
Description: SSP-G Variator Roller Weight Set 20x12 for Yamaha Vino and Yamaha Zuma 125 scooters. Lower your stock weight (12-14gm) with 10gm or 11gm for a great performance upgrade for better take and just plain replacing worn-out stock weights. 20x12mm roller set for Yamaha Vino, Yamaha Zuma 125, and many other scooters.
For those of you unfamiliar with roller weights, they are an important tuning device and have a significant impact on your scooter's performance! They should be checked/changed every 1000 miles (per maintenance schedule) to keep your scooter running tops. Over time, roller weights will develop flat spots which will impair the performance of your scooter.
A good indication that your rollers are worn is increasingly high revs for a given speed and/or decreased top speed. Replacing worn rollers will restore and actually improve your low-end power and especially your top speed. Fuel efficiency will also improve dramatically!
Includes 36 Roller Weights, from 7gm to 18gm. Lighter roller weights will increase RPM for any given road speed. Heavier weights will lower RPM for any given road speed. Must be put in a 120° pattern!
NOTE: Before use, lubricate slider grooves, slider pins, ball bearing seat, and inner funnel area with heat-resistant moly-graphite grease.
Installation: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face slop-side and boss flat-side. Should be flushed together. 3. Then install the existing variator fan, washer, and hand-tight nut. 4. Finally, apply blue Loctite, torque nut to 30-35ft-lbs. For reassurance please consult your manufacturer's variator torque specs.
Include the following Roller weight set.
• 6x Roller Weights: 20x12mm 7gm<18gm
• Made in Taiwan
• Fit Variator Housing: 117.5mm or 122mm / Slides: 3 / Top: 89mm / Boss: 20mm / Shims: 20mm / Drive Splines: 15
• Fit Belt Size: 759-22-30 (Vino)
• Fit Belt Size: 790.5-21.9, 810-22-28 (Zuma)
• Fit BWS 125
• Fit Vino 125
• Fit Zuma 125
Supported Models: NCY CVT KIT (Part# 1200-1047); Kymco 300, Yamaha Linhai 260/300, Asia/European model Cygnus 125, Yamaha BW's 125, Yamaha Cygnus 125, Yamaha GTR 125, Yamaha Vino 125, Yamaha Zuma 125
Item Weight & Package Dimensions:
• 1.025 pounds | 9.5" (L) x 5.93" (W) x 0.64" (H)
From Same Category
- Stock: 38
- Reward Points: 1
- Part #: 169-492