Main Menu
Your Cart

Stage6 Drive Face CNC-Machined (Aprilia, JOG, Zuma 50)

Stage6 Drive Face CNC-Machined (Aprilia, JOG, Zuma 50)
Stage6 Drive Face CNC-Machined (Aprilia, JOG, Zuma 50)
Stage6 Drive Face CNC-Machined (Aprilia, JOG, Zuma 50)
Stage6 Drive Face CNC-Machined (Aprilia, JOG, Zuma 50)
Stage6 Drive Face CNC-Machined (Aprilia, JOG, Zuma 50)
Stage6 Drive Face CNC-Machined (Aprilia, JOG, Zuma 50)
Description: Stage6 Drive Face CNC-Machined for Aprilia, JOG, Zuma 50, and many other 50cc base engines. Drive face with optimized drive face angle. In order to keep costs down, original racing drives are usually cast or - even worse - pressed steel. When these parts are cooling down after casting, the metal is still molten and the drive face angles can often vary. Due to the fact that racing engines have a very narrow power band, these tolerances have direct consequences on the power output. In contrast to those standard versions, the Stage6 racing drive is precisely CNC cut out of solid material. All in all, more than twelve different versions were tested to find the optimal angle. The high-quality alloys and the special surface coating used in this drive face make cooling fins unnecessary. The reduced mass has of course positive results for the power at the rear wheel. This racing drive was actually developed for drag races, but Freddy Koopmans also used them with his racing scooters in the 2004 season.

Installation: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face slop-side and boss flat-side. Should be flushed together. 3. Then install the existing variator fan, washer, and hand-tight nut. 4. Finally, apply blue Loctitetorque nut to 30-35ft-lbs. For reassurance please consult your manufacturer's variator torque specs.

Specifications:

•    1x Aluminum CNC Machined Drive Face Weight: gm
•    ID: mm / OD: mm / H: mm
•    Made in Italy
•    Fit Aprilia 50
•    
Fit JOG 50
•    Fit Zuma 50

Supported Models: Explorer Race GT 50, Garelli GSP 50, Italjet Dragster 50, KTM Ark 50, Kalio K50, Karcher KM 50, Keeway Agora 50, Kreidler Florett 50,  Yamaha C3, Yamaha Zuma CW50, Yamaha Zuma 50F, Yamaha Vino Minarelli Jog engines, Chinese Yamaha Clones 1PE40QMB 1E40QMB engines, Malaguti, CPI, Aprilia Scooters with Piaggio engines, Znen, and virtually any scooter engine with these measurements.

-----
Item Weight & Product Dimensions:
•    0.212 pounds | 3.688” (OD) x 0.551” (ID) x 0.787” (H)


Write a review

Note: HTML is not translated!
Bad Good
Captcha
Stage6 Drive Face CNC-Machined (Aprilia, JOG, Zuma 50)
  • Stock: 40
  • Reward Points: 1
  • Part #: S6-5116600
Sold: 0
Views: 193
$36.75
Ex Tax: $36.75
Price in reward points: 37

Included