Dr. Pulley Variator 114mm Set (GY6)
Description: Dr. Pulley's products are some of the best on the market today! This racing variator from Dr. Pulley is precision-engineered to increase performance over stock GY6variators. The steep angle ramp plates in the Dr. Pulley Variators allow for a faster and smoother engagement at all speeds, allowing lighter weighted sliders to fully extend to make the most of your CVT system. The Dr. Pulley GY6 Variator comes with the variator, fan plate, center boss pin, and washers. Rollers or sliders not included. This will also work on the Polaris RZR 170.
The Dr. Pulley Variator Set includes a variator boss, variator, slides, machined drive face, and space-washers. Pair these with Dr. Pulley’s Roller (Part# 169-238) or Sliders Weights (Part# 169-218) for the best performance you can get out of your Dr. Pulley Variator.
NOTE: For some models like the Polaris RZR 170 you'll need to widen the Dr. Pulley Variator Top plate center hole, with a dremel tool, to fit through its variator shaft. Recommend using a new belt with this kit. Belt and the belt drive-facing plates KEEP DRY. All, other areas apply moly-graphite grease when assembling.
Installation: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face slop-side and boss flat-side. Should be flushed together. 3. Then install the existing variator fan, washer, and hand-tight nut. 4. Finally, apply blue Loctite, torque nut to 30-35ft-lbs. For reassurance please consult your manufacturer's variator torque specs.
Includes the following Variator boss, Variator drive face, Variator housing, Variator slides, Variator top, and Shims.
• 1x Alumin-Alloy Housing Gray ID: 24mm / OD: 114mm / H: 36mm
• 1x Stainless Steel Boss L: 38mm / ID: 15mm / OD: 24mm
• 1x Metal Top ID: 15mm / OD: 86.9mm / H: 22mm
• 3x Plastic Slides
• 2x Metal Shims: 24mm
• Made in Taiwan
• Fit Variator Weights: 18x14mm
• Fit Variator/Clutch Shaft Nuts: M12 / Washers: M12 / Socket: 17mm
• Fit Belt Size: 743, 835, 842-20-30
• Fit Dowel Pin Set (8x10mm)
• Fit GY6 125/150cc+
Supported Models: SSP-G CVT KIT (Part# 169-530); GY6 152QMI 157QMJ 161QMK 161QML Chinese Scooter, ATV, Genuine Buddy, Kymco, Polaris RZR 170, Ruckus, Vento
Item Weight & Product Dimensions:
• 1.106 pounds | 4.528" (L) x 4.528" (W) x 2.968" (H)
People Also Bought
- Stock: 15
- Reward Points: 3
- Part #: 1200-1135